Accessories for wall heating/cooling dry construction and plaster system

• Three-way co-extruded, oxygen-tight polybutene pipe (red), according to DIN 4726/27 and DIN EN 12319, particular for the wall heating plaster system
  
• 200 m per roll

• The wall heating is an alternative or supplement to underfloor heating. It is a plaster system with clamping rail for mounting on solid walls (e.g. brick, concrete or sand-lime brick). The wall heating that is to be set up of site is plastered in with a pipe covering of roughly 15 mm (single-layer plaster structure for gypsum plaster). Cement-bound and clay plasters are processed with two layers and left to dry in accordance with manufacturer’s instructions, also with a pipe covering of roughly 15 mm. To prevent crack formation, a reinforcement fabric is embedded. The heating pipe to be used is an oxygen-tight polybutene pipe in accordance with DIN 4726 (12 x 1.3 mm) that is laid individually at various height and width dimensions (up to max. 6 m²). The pipe is connected directly to the distributor (with no collector lines) with compression fittings.
  
• For connecting the PB heating pipe to the system manifold, Eurocone
  
• PU = 1 unit

• Wall heating / cooling plastering system
  The wall heating is an alternative or supplement to underfloor heating. It is a plaster system with clamping rail for mounting on solid walls (e.g. brick, concrete or sand-lime brick). The wall heating that is to be set up of site is plastered in with a pipe covering of roughly 15 mm (single-layer plaster structure for gypsum plaster). Cement-bound and clay plasters are processed with two layers and left to dry in accordance with manufacturer’s instructions, also with a pipe covering of roughly 15 mm. To prevent crack formation, a reinforcement fabric is embedded. The heating pipe to be used is an oxygen-tight polybutene pipe in accordance with DIN 4726 (12 x 1.3 mm) that is laid individually at various height and width dimensions (up to max. 6 m²). The pipe is connected directly to the distributor (with no collector lines) with compression fittings.
  For wall mounting for fastening the pipe
  12 x 1.3 mm, length: 2 m.
  Fastening with conventional hammer-in wall plugs.
  
• PU: 16 units, 2 m each = 32 m

• Reinforcement fabric for plaster, alkali-free.
  
• Mesh size: 6 mm
  
• Roll: 1 mm x 50 m
  

For safe connection of panel edges, with special nozzle. About 1 tube is required per 5 m². ...

• With TH profile for wall heating 12 x 1.3 mm