GOK: Maintenance accessories and measuring instruments
- Consists of monitoring unit and sensor
If fluid (heating oil EL, diesel fuel, biodiesel, lubricating oils, water) wets the tube resistor sensor, the monitoring device raises the alarm with an LED - At the same time, a floating contact is connected that disconnects the socket
- Power supply: AC 230 V / 50 Hz
- Consists of monitoring unit and sensor
If fluid (heating oil EL, diesel fuel, biodiesel, lubricating oils, water) wets the tube resistor sensor, the monitoring device raises the alarm with an LED - At the same time, a floating contact is connected that disconnects the socket
- Power supply: AC 230 V / 50 Hz
- Consists of monitoring unit and sensor
If fluid (heating oil EL, diesel fuel, biodiesel, lubricating oils, water) wets the tube resistor sensor, the monitoring device raises the alarm with an LED - At the same time, a floating contact is connected that disconnects the socket
- Power supply: AC 230 V / 50 Hz
- Display device for indoors and outdoor areas that are protected from the weather
- Protection type: IP 54
- For local content measurement of depressurised oil tanks
- Display device for indoors and outdoor areas that are protected from the weather
- 2 relays with NC and NO contact max. 250 V AC, 3.5 A
- Protection type: IP 54
- Display device for dry and protected rooms
- 1 relays with NC and NO contact max. 250 V AC, 3.5 A
- Protection type: IP 30
- Battery-operated electronic remote content indicator for depressurised oil tanks
- Digital display unit with 16-digit LCD display
- Batteries can also be charged via power bank
- Incl. tube resistor for flexible installation
- For tanks, boiler rooms, collection trays
- Electrical connection: 230 V/50-60 Hz, IP 30
- For pressure testing before commissioning of an oil burning system in accordance with DIN 4755 or TRÖI
- Connection: RVS 8 mm
- Testing pressure up to 5 bar
- The test duration according to TRÖI chapter 4.10.4.2. "Tightness test with negative pressure" is:
- 10 minutes for above-ground pipes
- 30 minutes for underground pipes - Consisting of a connection block with integrated shut-off valve, in which a vacuum gauge and a vacuum limiter are mounted
- The suction pressure of the suction pump is limited to the specified test vacuum of -0.3 bar
- Measurement range: 0-200 cm
- Screw-in thread DN 40 (1 1/2”) ET
- Level sensor 0 to 250 mbar with 6 m cable
- Essential for extension of the probe cable to the smart box
- is an electronic remote content indicator for depressurised tanks.
- Output of the measurement data on the display of the digital indicator either in litres, volume percentage (V/V) or as fill level in cm
- Simple and menu-guided input of parameters by selecting from pre-installed tank shapes
- The following functions are displayed on the device:
- State of charge of the Batteries
- Heating up of the limit value transmitter
- Short circuit
- Interruption
- Release - Batteries included (2x 9 V block)
- For the comprehensive functional testing of Safety devices limit value sensors (type B1 sensors) in accordance with EN 13616
- Displayed functions:
- State of charge of the built-in Batteries
- Heating up of the limit switch
- Short circuit
- Interruption
- Release
- Response time - Scope of delivery:
- Coupling socket, suitable for all limit value transmitter connection devices
- With transport case
- With Chargers