OILPRESS KELLER®
- DN 10 (3/8") cylindrical
- Incl. special seal
- For supplying oil stoves and oil burners with EL heating oil with an organic proportion up to 20%
- With internal gear pump
- Housing and container made of stainless steel
- For low-viscosity media
- Pumps: 230 V, 50 Hz, 50 W (IP 64)
- Delivery rate: approx. 100 l/h (water at 0 bar)
- For single-walled communicating tanks made of PE/PA
- All OILPRESS fittings are suitable for heating oil with up to 20% biogenic content
- Compliant with TRwS 791 and AWSV
- For low-viscosity media
- Pumps: 230 V, 50 Hz, 50 W (IP 64)
- Delivery rate: approx. 100 l/h (water at 0 bar)
- For double-walled safety tanks and GF tanks, which may be
installed without a drip tray. - All OILPRESS fittings are suitable for heating oil with up to 20% biogenic content
- Compliant with TRwS 791 and AWSV
- For single-walled communicating tanks made of PE/PA
- All OILPRESS fittings are suitable for heating oil with up to 20% biogenic content
- Compliant with TRwS 791 and AWSV
- For single-walled communicating tanks made of PE/PA
- All OILPRESS fittings are suitable for heating oil with up to 20% biogenic content
- Compliant with TRwS 791 and AWSV
- With backflow preventer (foot valve), e.g. for conveying units with return
- For individual tanks up to 1,000 litres, earth tanks, battery containers according to DIN 6620 and cell-welded tanks according to DIN 6625.
- With quick-release valve and plastic screw-in body for electrical separation of oil line and tank.
- Suitable for Oilpress Model 180, 230, 240, 330
- Ref. no.: 004.423
- Resistant to heating oil
- ø 9 x 2 mm
- As a replacement hose
- Mains connection: 230 V-8 W ~ 50 Hz
- Stagnation pressure: approx. 2 bar
- Connection: 8 mm
- Mains connection: 230 V-8 W ~ 50 Hz
- Stagnation pressure: approx. 2 bar
- Connection: 8 mm
- For connection to the individual tanks
- Ø 10 mm
- Length 1,000 mm
- Without backflow preventer, e.g. for conveying units without return
- For individual tanks up to 1,000 litres, earth tanks, battery containers according to DIN 6620 and cell-welded tanks according to DIN 6625.
- With quick-release valve and plastic screw-in body for electrical separation of oil line and tank.
- Seal set for Keller OILPRESS plastic base units.
- To quickly and safely seal the cylindrical screw-in connection with the suction and return connection.
- PU: 10 units
- Suitable for Oilpress model 180, 240
- Ref. no.: 077.422
- Tested according to DIN 12514-1
- Delivery pressure: limited to approx. 4 bar by pressure relief valve
- Discharge head: 15 m factory setting
- DN 10 (3/8") ET
- With oil-resistant rubber seal (e.g. junction to foot valve)
- All OILPRESS fittings are suitable for heating oil with up to 20% biogenic content
- Compliant with TRwS 791 and AWSV
- Tested for odour tightness