alre

• 4-channel wireless receiver
  
• 4 NC relay contacts 5 (1) A
  
• Max. 4 actuators can be directly connected per heating circuit (max. total 16 actuators)
  

• Protection type: IP30
  
• Protection class: II
  
• Regulator for time-dependent heating / cooling regulation of 2- and 4-pipe systems
  

• Consisting of:
  
• 2 plastic duct connectors 2 x 90° angle
  
• 2 extensions 90 mm
  

• Technical data:
  
• Switching capacity: 15 (8) A, 24–250 V ~, for 24 V ~ min. 150mA
  
• Switching differential: > = 1 m / s
  

- Displays: 3-colour LED, one LED per Ducts if there are several receiving Ducts- For installation in the heating manifold- Pump module included- Master-slave operation- Status display of the radio connection for each Ducts- Antenna integrated in receiver strip- Only suitable for ALRE radio Room the ...

• Control switch
  
• For oil, water and air
  
• Predominantly used with pressure storage pumps for control and monitoring in oil pressure supply systems
  

• Protection type: IP30
  
• Protection class: II, subject to correct assembly
  
• Regulator for time-dependent single-room or floor temperature regulation for electrical and hot water heating
  

• Operating voltage: 250 V, 50/60 Hz
  Features: Toggle switch (change-over contact, max. 5 actuators)
  
• Very flat design - Berlin 1000 design
  
• Probe: bi-metal
  

• Operating voltage: 24 V, 50/60 Hz
  Features: NO contact, lowering
  
• Very flat design - Berlin 1000 design
  
• Probe: bi-metal
  

• 1-channel wireless receiver
  Technical data:
  
• Operating voltage: 230 V~, 50 Hz
  
• Transmission frequency: 868.3 MHz
  

• Operating voltage: 250 V, 50/60 Hz
  Features: NO contact, lowering
  
• Very flat design - Berlin 1000 design
  
• Probe: bi-metal
  

• Operating voltage: 250 V, 50/60 Hz
  Features: Toggle switch (change-over contact, max. 5 actuators), “heating/cooling” switch
  
• Very flat design - Berlin 1000 design
  
• Probe: bi-metal
  

• Operating voltage: 250 V, 50/60 Hz
  Features: NO contact, lowering, “ ON/OFF switch”, “heating” lamp
  
• Very flat design - Berlin 1000 design
  
• Probe: bi-metal
  

- Displays: 3-colour LED, one LED per Ducts if there are several receiving Ducts- For installation in the heating manifold- Pump module included- Master-slave operation- Status display of the radio connection for each Ducts- Antenna integrated in receiver strip- Only suitable for ALRE radio Room the ...

• Ready-to-use paste in dispenser
  
• Working temperature range: -40°C to 150°C
  
• Thermal conductivity: > 0.7W/mK, R
  

• Temperature sensor with set point adjuster
  
• With „Comfort/ECO“ operating mode switch
  
• „Berlin 1000, super flat“ building design
  

• Protection type: IP65
  
• Protection class: III
  
• Use outdoors, in damp rooms, cold stores, greenhouses and industrial areas
  

• Operating voltage: 250 V, 50/60 Hz
  Features: NO contact
  
• Very flat design - Berlin 1000 design
  
• Probe: bi-metal
  

• Protection type: IP65
  
• Protection class: III
  
• Temperature measurement for liquid or gaseous media
  

• For room-temperature controlled operation
  
• The room temperature sensor is connected to the control system of the condensing boiler; the time program and the room temperature are set on the condensing boiler
  
• Installation location: Reference room (e.g. living room)
  

• Temperature sensor with clock and set point adjuster
  
• „Berlin 3000“ housing design, programming for every day is known by mechanical timers using „electronic tabs“ (minimal switching time 15 min)
  
• Lowering can be adjusted via clock
  

• Temperature sensor with set point adjuster
  
• „Berlin 1000, super flat“ building design
  
• Lowering: 4 K (fixed) can only be activated via master-slave mode with a clock transmitter
  

• In the event of sensor screed mounting
  
• Internal ø 8 mm

• Protection class: IP40
  
• Protection class: I
  
• Suitable for heating technology, ventilation technology and for controlling and monitoring temperatures on pipes
  

• Protection type: IP42
  
• Protection class: II
  
• Electrothermal valve actuators for heating, ventilation and air-conditioning equipment
  

• Technical data:
  
• Switching capacity: 15 (8) A, 24–250 V~, at 24 V~ min. 150 mA
  
• Contact: 1 micro-switch used as floating changeover contact (changeover switch)
  

• Capillary system
  
• Design certified by TÜV according to DIN EN 14597, for hot-air heater to DIN 4794
  Technical data:
  
• Switching capacity: 15 (8) A, 24–250 V~, at 24 V~ min. 150 mA
  

• Developed in conjunction with an alre dew point monitor (e.g. WFRRN) or chilled ceiling controller (e.g. KTRRB, KTRRU, KTRRUu, KTRVB, KTFRx)
  
• Detection and signalling of the dew point
  
• Prevents condensation from dripping off the cooled parts of the cooling circuit
  

• Operating voltage: 230 V AC, 50Hz
  
• Switching current: 10(4)A
  
• Switching capacity: 2300W
  

• with internal sensor
  Technical Data:
  
• Measuring range: -30 to +100°C
  
• Tolerance classes:
  - PT100
  - DIN EN 60751 B
  

• Protection type: IP30
  
• Protection class: II, subject to correct assembly
  
• Regulator for time-dependent single-room or floor temperature regulation for electrical and hot water heating
  

• Protection type: IP30
  
• Protection class: II, subject to correct assembly
  
• Regulator for time-dependent single-room or floor temperature regulation for electrical and hot water heating
  

• Ambient temperature with PE cable: -35...+100°C
  
• Ambient temperature with silicon cable: -50...+150°C
  
• Protection type: IP 67
  

• For fixing individual controllers

• Protection type: IP30
  
• Protection class: II
  
• Regulator for time-dependent heating / cooling regulation of 2- and 4-pipe systems
  

• Connection thread DN 15 (1/2”)
  
• For industry and heating systems